Reasons and Improvement of Oil Leakage in floating seal

1. In the installation of floating oil seal process, because the O-ring is not properly installed and offset, not installed in place, this will make the sealing surface of the pressure is not the same, resulting in oil spills.

2. Because the diameter of the sealing chamber is too small, so that the compression force of the sealing ring is too small to reduce the pressure on the surface of the pressure, so that the gap will appear on the sealing surface, it will lead to oil spills.

3. As the ring long-term work in the gear oil, the temperature will be high, more than 100 degrees, so it is easy to make the rubber aging and no flexibility, and thus damage and produce oil spills.

What if we encounter such a situation?

First of all must improve the quality of the installation process, so that the O-ring can be installed in place; the appropriate increase in the amount of O-ring compression, so that the force surface of the normal force; seals to use high temperature, oil resistance.